Update Calibration
parent
fef7042a7b
commit
43dfa16aef
1 changed files with 9 additions and 11 deletions
|
@ -1,13 +1,12 @@
|
|||
## Up vision calibration
|
||||
|
||||
part placed too far to the right?
|
||||
increase X camera position
|
||||
increase X camera position
|
||||
part placed too far to the left?
|
||||
decrease X camera position
|
||||
decrease X camera position
|
||||
part placed too far to the back?
|
||||
increase Y camera position
|
||||
increase Y camera position
|
||||
part placed too far to the front?
|
||||
decrease Y camera position
|
||||
decrease Y camera position
|
||||
|
||||
part measurement width too high?
|
||||
decrease "Distance/Pixel" X (first value)
|
||||
|
@ -30,24 +29,24 @@ These values calibrate the 0mm depth, e.g. for the PCB this is the level of the
|
|||
4. adjust Z value of "Down To PCB"
|
||||
5. repeat from 2. until done, else click "Nozzle Up"
|
||||
|
||||
"Down To Stack"
|
||||
#### "Down To Stack"
|
||||
1. manually move nozzle 1 over a pick position of a tape feeder stack (ideally no.1 of the left stack), no tape inserted
|
||||
2. click "Nozzle Down"
|
||||
3. nozzle 1 should just touch the metal surface of the pick position
|
||||
4. adjust Z value of "Down To Stack"
|
||||
5. repeat from 2. until done, else click "Nozzle Up"
|
||||
|
||||
"Down To Front"
|
||||
#### "Down To Front"
|
||||
1. manually move nozzle 1 over a pick position of the front IC stack, no part, just the bare stack where a part would sit
|
||||
2. click "Nozzle Down"
|
||||
3. nozzle 1 should just touch the metal surface of the pick position
|
||||
4. adjust Z value of "Down To Stack"
|
||||
5. repeat from 2. until done, else click "Nozzle Up"
|
||||
|
||||
"Down To Discard"
|
||||
#### "Down To Discard"
|
||||
Well, this depends on your discard position and preference.
|
||||
|
||||
"NozzleOffset(X,Y)"
|
||||
### "NozzleOffset(X,Y)"
|
||||
1. create a reference, ideally a thin lined cross (like a bullseye)
|
||||
2. "System Config" -> "Nozzle" -> "Measure"
|
||||
3. aim center of cross with down vision
|
||||
|
@ -58,8 +57,7 @@ Well, this depends on your discard position and preference.
|
|||
8. click "Nozzle alignment reference point" "Nozzle2:" "SetXY"
|
||||
9. click "Save"
|
||||
|
||||
Prick calibration
|
||||
-----------------
|
||||
## Prick calibration
|
||||
1. choose vision mode
|
||||
2. down vision aim part at pick position, click "Set XY"
|
||||
this uses always the same button:
|
||||
|
|
Loading…
Reference in a new issue