From 82c163ee93cc4fbdadf2940e63adfd15f75b5fbe Mon Sep 17 00:00:00 2001 From: Nicole Faerber Date: Tue, 24 Mar 2020 16:35:05 +0100 Subject: [PATCH] Update Calibration --- Calibration.md | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/Calibration.md b/Calibration.md index 1902861..eb91f1e 100644 --- a/Calibration.md +++ b/Calibration.md @@ -67,8 +67,8 @@ this uses always the same button: 4. click "Prick Comp" - this will move the tape one component 5. click "Nozzle MoveTo" - this will move nozzle 1 down to the component, nozzle should sit on center of component, if not: - a) too far left: decrease "PrickOffset" X - b) too far right: increase "PrickOffset" X - c) prick does not land in tape hole, too far to the back: decrease "PrickOffset" Y - c) prick does not land in tape hole, too far to the front: increase "PrickOffset" Y + 1. too far left: decrease "PrickOffset" X + 2. too far right: increase "PrickOffset" X + 3. prick does not land in tape hole, too far to the back: decrease "PrickOffset" Y + 4. prick does not land in tape hole, too far to the front: increase "PrickOffset" Y 6. repeat from 3. until nozzle lands in center of part \ No newline at end of file